| Error # |
Fix / Info |
Termination Code |
Termination Reason |
| 0 |
none |
stillActive(0) |
Call is currently connected |
| 1 |
none |
notKnown(1) |
Unknown |
| 2 |
none |
idleTimeout(2) |
Call exceeded idle timeout parameter |
| 3 |
none |
killed(3) |
Call terminated by administrator |
| 4 |
none |
takeLinkDown(4) |
Unknown |
| 5 |
none |
userHangup(5) |
DSP discovered remote modem
was hung up abruptly. Examples could be that the phone line was pulled
out of the wall jack or the user terminated the communications without
closing the connection down. If the modems are unable to bring up the
physical line by successfully negotiating the modulation, userHangup will
be registered if the remote modem gave up trying to complete the call. |
| 6 |
none |
modemCanNotConnect(6) |
The modems are not able to
bring up the physical line by successfully negotiating the modulation.
The RAS has given up trying further to complete the physical connection |
| 7 |
none |
modemError(7) |
Unknown |
| 8 |
none |
pppClose(8) |
This termination reason will
be given after PPP is initated and the connection is disconnected. An example would be if LCP
negotiations failed. Another cause could be if the bundlehead in a multilink
call is terminated before the tunneled call is termination. |
| 9 |
none |
lcpClose(9) |
Close initiated by LCP. This
is a normal shutdown of a call |
| 10 |
none |
loginTimeOut(10) |
Exceeded login timeout parameter |
| 11 |
none |
userTerminated(11) |
A problem is discovered initiating the dial-in users telnet, rlogin or tcpclear
session. |
| 12 |
none |
noPoll(12) |
Internal RAS error. Please contact Patton
technical support if you see these termination reasons. |
| 13 |
none |
ipcPutMsdErr(13) |
Internal RAS error. Please contact Patton
technical support if you see these termination reasons. |
| 14 |
none |
invalidAuthMsg(14) |
Unknown |
| 15 |
none |
pollErr(15) |
Internal RAS error. Please contact Patton
technical support if you see these termination reasons. |
| 16 |
none |
ioctlErr(16) |
Internal RAS error. Please contact Patton
technical support if you see these termination reasons. |
| 17 |
none |
pppPutMsgErr(17) |
Internal RAS error. Please contact Patton
technical support if you see these termination reasons. |
| 18 |
none |
dspIoctlErr(18) |
Internal RAS error. Please contact Patton
technical support if you see these termination reasons. |
| 19 |
none |
timerErr(19) |
Internal RAS error. Please contact Patton
technical support if you see these termination reasons. |
| 20 |
none |
authClean(20) |
Unknown |
| 21 |
none |
maxNumCalls(21) |
Exceeds maximum number of
channels that can be allocated to the same call. |
| 22 |
none |
pppOpenErr(22) |
Internal RAS error. Please contact Patton
technical support if you see these termination reasons. |
| 23 |
none |
ipLinkErr(23) |
Internal RAS error. Please contact Patton
technical support if you see these termination reasons. |
| 24 |
none |
notPapReq(24) |
The RAS is waiting for a PAP
request packet containing the username/password for a call but the packet
received was not a PAP request packet. |
| 25 |
none |
pppLinkErr(25) |
Unknown |
| 26 |
none |
tcpOpenErr(26) |
Internal RAS error. Please contact Patton
technical support if you see these termination reasons. |
| 27 |
none |
tcpPushErr(27) |
Internal RAS error. Please contact Patton
technical support if you see these termination reasons. |
| 28 |
none |
tcpPutMsgErr(28) |
Internal RAS error. Please contact Patton
technical support if you see these termination reasons. |
| 29 |
none |
invalidPrim(29) |
Internal RAS error. Please contact Patton
technical support if you see these termination reasons. |
| 30 |
none |
noIpPoolAddr(30) |
Authentication server did not
assign an IP address and access had no IP address pool defined to assign
an IP address |
| 31 |
none |
noIpAddr(31) |
Authenticator did not return
an IP address for the service (eg telnet or rlogin) and the default service
defined does not specify the service IP address |
| 32 |
none |
maxLoginAttempts(32) |
Exceeded maximum login attempts
as defined under the Dial-in link |
| 33 |
none |
noTimers(33) |
Internal RAS error. Please contact Patton
technical support if you see these termination reasons. |
| 34 |
none |
tcpLinkErr(34) |
Internal RAS error. Please contact Patton
technical support if you see these termination reasons. |
| 35 |
none |
dspLinkErr(35) |
Internal RAS error. Please contact Patton
technical support if you see these termination reasons. |
| 36 |
none |
dspPutMsgErr(36) |
Internal RAS error. Please contact Patton
technical support if you see these termination reasons. |
| 37 |
none |
noDsp(37) |
Internal RAS error. Please contact Patton
technical support if you see these termination reasons. |
| 38 |
none |
lisIpcErr(38) |
Internal RAS error. Please contact Patton
technical support if you see these termination reasons. |
| 39 |
none |
dspOpenErr(39) |
Internal RAS error. Please contact Patton
technical support if you see these termination reasons. |
| 40 |
none |
invalidCode(40) |
Internal RAS error. Please contact Patton
technical support if you see these termination reasons. |
| 41 |
none |
callContention(41) |
Internal RAS error. Please contact Patton
technical support if you see these termination reasons. |
| 42 |
none |
dspCommErr(42) |
Internal RAS error. Please contact Patton
technical support if you see these termination reasons. |
| 43 |
none |
unknownBearerContent(43) |
Internal RAS error. Please contact Patton
technical support if you see these termination reasons. |
| 44 |
none |
invalidDefaults(44) |
Default service is set to a value
other than rlogin, telnet, tcpraw, ppp, slip or vpn when using a login
technique of None. No IP address
is defined when using rlogin or telnet.
Invalid telnet or rlogin services ports have been defined in the
default service. |
| 45 |
none |
noDspAvailable(45) |
When
the RAS attempted to connect the incoming call
to an available DSP, no DSP could be found. |
| 46 |
none |
dspOutOfState(46) |
Internal RAS error. Please contact Patton
technical support if you see these termination reasons. |
| 47 |
none |
dspRequestUnsupported(47) |
Internal RAS error. Please contact Patton
technical support if you see these termination reasons. |
| 48 |
none |
dspBadPrimitive(48) |
Internal RAS error. Please contact Patton
technical support if you see these termination reasons. |
| 49 |
none |
papAuthenticationFailure(49) |
Invalid username/password
combination |
| 50 |
none |
papInvalidPacket(50) |
Non-printable characters in username
or password received from remote end during authentication |
| 51 |
none |
authenServerTimeout(51) |
Authentication request timed
out. The RADIUS server did not send a response to the authentication request
before the timer expired. |
| 52 |
none |
authenAccountingTimeout(52) |
Accounting request timed out.
The RADIUS server did not send a response to the accounting request before
the timer expired. |
| 53 |
none |
unknownProtocol(53) |
The user imitates a PPP connection
but the RADIUS replies to the RAS that the user is not allowed to connect
using PPP. |
| 54 |
none |
mfr2DisWaitCalled(54) |
Call disconnected while we were
waiting for the next expected called number digit.
The number of called number digits expected is more than the digits
actually being sent or the Last response code is configured incorrectly
so the RAS and switch can not continue on with the interregister signaling. |
| 55 |
none |
mfr2DisAckCalled(55) |
Call disconnected while we were
in the process of sending back the ack tone for a called number digit
or while we were waiting for the termination of the far end tone in response
to our ack. |
| 56 |
none |
mfr2DisAckLastCalled(56) |
Call disconnected while we were
in the process of sending back the ack tone for the last expected called
digit or while we were waiting for the termination of the far end tone
in response to our ack. |
| 57 |
none |
mfr2DisWaitCalling(57) |
Call disconnected while we were
waiting for the next expected calling number digit.
The number of calling number digits expected is more than the
digits actually being sent or the Last response code is configured incorrectly
so the RAS and switch can not continue on with the interregister signaling. |
| 58 |
none |
mfr2DisAckCalling(58) |
Call disconnected while we were
in the process of sending back the ack tone for a calling number digit
or while we were waiting for the termination of the far end tone in response
to our ack |
| 59 |
none |
mfr2DisAckLastCalling(59) |
Call disconnected while we were
in the process of sending back the ack tone for the last expected calling
digit or while we were waiting for the termination of the far end tone
in response to our ack. |
| 60 |
none |
mfr2DisWhileComplete(60) |
Call disconnected after the last
expected digit was sent and acked. The number of calling digits expected
may be less than the number of digits sent or the last response code for
the calling number is incorrect. |
| 61 |
none |
tcpSideClosure(61) |
There is a problem connecting
to the IP Address or the port specified. |
| 62 |
none |
telnetError(62) |
There is a problem connecting
to the IP Address or the port specified. |
| 63 |
none |
rloginError(63) |
There is a problem connecting
to the IP Address or the port specified. |
| 64 |
none |
exceedsMultiLinkLimit(64) |
Exceeds multilink channel limit
set either on the remote access server or in the user entry on the RADIUS
server |
| 65 |
none |
lcpNegotiationFailure(65) |
Unknown |
| 66 |
none |
sessionTimeout(66) |
The length of the connection
exceeds the session time limit allowed |
| 67 |
none |
tcpConnAborted(67) |
Connection to the remote service
has been disconnected abruptly. For example, the administrator of the
remote machine killed the process. |
| 68 |
none |
tcpNoBuffers(68) |
Internal RAS error. Please contact Patton
technical support if you see these termination reason: |
| 69 |
none |
tcpConnRefused(69) |
Connection to specified service
on the remote machine was refused |
| 70 |
none |
tcpConnReset(70) |
Connection was reset |
| 71 |
none |
tcpTimedOut(71) |
Request to initiate connection
to the remote service timed out. Connection timed out because the remote
side did not respond on the connection in a timely manner. |
| 72 |
none |
noLnsIpAddr(72) |
Unknown |
| 73 |
none |
noDefaultLns(73) |
Unknown |
| 74 |
none |
vpnPeerRejected(74) |
Unknown |
| 75 |
none |
udpOpenError(75) |
Internal RAS error. Please contact Patton
technical support if you see these termination reasons. |
| 76 |
none |
udpBindErr(76) |
Internal RAS error. Please contact Patton
technical support if you see these termination reasons. |
| 77 |
none |
lstpOpenErr(77) |
Internal RAS error. Please contact Patton
technical support if you see these termination reasons. |
| 78 |
none |
l2tpLinkErr(78) |
Internal RAS error. Please contact Patton
technical support if you see these termination reasons. |
| 79 |
none |
reLinkErr(79) |
Internal RAS error. Please contact Patton
technical support if you see these termination reasons. |
