Rockwell/Conexant HCF/HSF(Soft56)/ACF(driver version 3.xx) String
Rockwell HCF/HSF(Soft56)/ACF(driver version 3.xx) (connect probs, but retain v90)
AT: (beginning of most inits) Attention!
&F: (factory init) Set all commands to the most commonly used.
&C1: (DCD signal) required if software uses the Carrier Detect pin to check if a carrier is present.
&D2: (DTR Option) instructs the modem to hangup upon a DTR signal drop, the most common way software instructs it to do so.
+MS=v90,0: (select modulation) Set modulation to v90.
This page was last modified on Saturday, 05-Feb-2011 15:13:13 EST.