---

ModemHelp.Net Recommends: Free System Scan for PC Errors

Rockwell based 14.4 RPI Modem String Explaination

Rockwell based 14.4 RPI Modem

AT&FW2&C1&D2&K3S95=1

AT: (beginning of most inits) Attention!

&F: Sets the values loaded in the active profile to the values that are set in the default profile.

W2: (Extended result codes) sets modem to report CONNECT to DCE rather than DTE.

&C1: DCD enabled after a carrier signal is detected

&D2: DTR drop causes modem to hang up

&K3: Enable RTS/CTS flow control

S95=1: Use DCE when reporting CONNECT result codes