Outdated Drivers
Can cause hardware related Errors. Check your PC Drivers now.

Rockwell based 14.4 RPI+ Modem String Explaination


Rockwell based 14.4 RPI+ Modem

AT&F&C1&D3&K3+H11W2


AT: (beginning of most inits) Attention!

&F: Sets the values loaded in the active profile to the values that are set in the default profile.

&C1: DCD enabled after a carrier signal is detected

&D3: DTR drop causes the modem to be reinitialized

&K3: Enable RTS/CTS flow control

+H11: Enable RPI+ mode

W2: (Extended result codes) sets modem to report CONNECT to DCE rather than DTE.









This page was last modified on Saturday, 05-Feb-2011 15:13:13 EST.




 
This website is ©1999-Present Bradford Liedel DBA ModemHelp Networks and Web Services. Mason, MI 48854 USA. All rights reserved.