Rockwell based 14400 bps RPI Modem String Explaination
Rockwell based 14400 bps RPI Modem
AT&FW2&C1&D2&Q6&K3S7=60
AT: (beginning of most inits) Attention!
&F: Sets the values loaded in the active profile to the values that are set in the default profile.
W2: (Extended result codes) sets modem to report CONNECT to DCE rather than DTE.
&C1: DCD enabled after a carrier signal is detected
&D2: DTR drop causes modem to hang up
&Q6: Buffered asynchronous mode
&K3: Enable RTS/CTS flow control
S7=60: Wait at least 60 seconds for carrier before discontinuing connection attempt.
This page was last modified on Saturday, 05-Feb-2011 15:13:13 EST.
|
