Outdated Drivers
Can cause hardware related Errors. Check your PC Drivers now.

Rockwell based 28.8 V.34/V.FC Modem String Explaination

Rockwell based 28.8 V.34/V.FC Modem


AT: (beginning of most inits) Attention!

&F: Sets the values loaded in the active profile to the values that are set in the default profile.

W2: (Extended result codes) sets modem to report CONNECT to DCE rather than DTE.

&C1: DCD enabled after a carrier signal is detected

&D2: DTR drop causes modem to hang up

&K3: Enable RTS/CTS flow control

&Q5: Error correction mode

%C3: This command sets the data compression to both MNP5 and v.42bis

\N3: Auto-reliable or MNP auto-reliable mode

S7=50: Wait at least 50 seconds for carrier before discontinuing connection attempt.

S46=138: Modem will negotiate with a remote modem for data compression

S48=7: LAPM Error Control and Feature Negotiation enabled

This page was last modified on Saturday, 05-Feb-2011 15:13:13 EST.

This website is ©1999-Present Bradford Liedel DBA ModemHelp Networks and Web Services. Mason, MI 48854 USA. All rights reserved.