Outdated Drivers
Can cause hardware related Errors. Check your PC Drivers now.

Rockwell/Conexant HCF/HSF(Soft56)/ACF(driver version 3.xx) String Explaination

 

Rockwell HCF/HSF(Soft56)/ACF(driver version 3.xx) (continued connect problems)

AT&F&C1&D2s95=3

 

AT: (beginning of most inits) Attention!

&F: (factory init) Set all commands to the most commonly used.

&C1: (DCD signal) required if software uses the Carrier Detect pin to check if a carrier is present.

&D2: (DTR Option) instructs the modem to hangup upon a DTR signal drop, the most common way software instructs it to do so.

s95=3: (extended result codes) Enable PROTOCOL XXXX result code (XXXX = protocol identifier).











This page was last modified on Saturday, 05-Feb-2011 15:13:13 EST.




 
This website is ©1999-Present Bradford Liedel DBA ModemHelp Networks and Web Services. Mason, MI 48854 USA. All rights reserved.