Outdated Drivers
Can cause hardware related Errors. Check your PC Drivers now.

Rockwell/Conexant ACF String Explaination

 

Rockwell ACF (force v34 #3)

AT&F&C1&D2&K3+MS=11

 

AT: (beginning of most inits) Attention!

&F: (factory init) Set all commands to the most commonly used.

&C1: (DCD signal) required if software uses the Carrier Detect pin to check if a carrier is present.

&D2: (DTR Option) instructs the modem to hangup upon a DTR signal drop, the most common way software instructs it to do so.

&K3: (Flow control) Enables RTS/CTS flow control.

+MS=11: (select modulation) Set modulation to v34.











This page was last modified on Saturday, 05-Feb-2011 15:13:13 EST.




 
This website is ©1999-Present Bradford Liedel DBA ModemHelp Networks and Web Services. Mason, MI 48854 USA. All rights reserved.