---

Outdated Drivers Can cause hardware related Errors. Check your PC Drivers now.

Rockwell/Conexant ACF String Explaination

Rockwell ACF (dropped connect probs)

AT&F&C1&D2s10=200s25=100s91=14

AT: (beginning of most inits) Attention!

&F: (factory init) Set all commands to the most commonly used.

&C1: (DCD signal) required if software uses the Carrier Detect pin to check if a carrier is present.

&D2: (DTR Option) instructs the modem to hangup upon a DTR signal drop, the most common way software instructs it to do so.

s10=200: (lost carrier hangup delay) sets the hangup delay for a lost carrier to 20 seconds.

s25=100: (ignore DTR drop time) sets the amount of time that the modem ignores a DTR drop to 10 seconds.

s91=13: (transmission level) sets the signal level of the transmission to -13dBm