RPI+ 2nd generation WITH DRIVERS String Explaination
RPI+ 2nd generation WITH DRIVERS
AT: (beginning of most inits) Attention!
This page was last modified on Saturday, 05-Feb-2011 15:13:13 EST.
&F: Sets the values loaded in the active profile to the values that are set in the default profile.
&C1: DCD enabled after a carrier signal is detected
&D2: DTR drop causes modem to hang up
&K3: Enable RTS/CTS flow control
+H11: Enable RPI+ mode
S95=1: Use DCE when reporting CONNECT result codes