Rockwell Internal V.32bis Modem (V.42bis) String Explaination
Rockwell Internal V.32bis Modem (V.42bis)
AT: (beginning of most inits) Attention!
This page was last modified on Saturday, 05-Feb-2011 15:13:13 EST.
&F: Sets the values loaded in the active profile to the values that are set in the default profile.
H0: This command determines that the modem is on-hook (hangs up).
W2: (Extended result codes) sets modem to report CONNECT to DCE rather than DTE.
X4: Busy and dialtone detection enabled. Result codes 0-7,10 enabled
&D3: DTR drop causes the modem to be reinitialized
\J0: Serial port speed remains locked
\N3: Auto-reliable or MNP auto-reliable mode
S7=60: Wait at least 60 seconds for carrier before discontinuing connection attempt.